Garage door won't close: sensor repair in South Windsor

A door that starts down and comes straight back up is nearly always telling you about its safety sensors.

Call (860) 385-8584

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In South Windsor, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Chain-drive garage door opener under exposed rafters

Doors that won't close in South Windsor

South Windsor's older houses along Main Street and in East Windsor Hill have barns and detached garages where the sensor wire runs a long way and is exposed to weather and animals. In the Wapping section and the newer subdivisions, the garages are attached and busy, and the trouble is more often a west-facing door: late-afternoon sun shines straight into the receiving sensor and the door won't close until the sun moves. A small shield or swapping the two sensors side to side usually cures it.

The usual reasons a door reverses or stays open

  • Misaligned photo-eyes. A bin, a bike tire or a broom knocks one bracket a few degrees and the beam misses.
  • Dirt, cobwebs or condensation on a lens. The sensor sees it as an obstacle.
  • Low sun shining straight into the receiving eye. It happens at the same hour each day and clears up later.
  • Damaged sensor wire. Staples, rodents and corrosion all break the thin low-voltage wire.
  • Close limit or force out of adjustment. The door reaches the floor and the opener reads it as a collision.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around South Windsor

  • East Windsor Hill: The north end of Main Street near the Scantic River.
  • Avery Heights: Post-war ranches and capes off Avery Street.

See the full South Windsor service area.

Door stuck? Call before you try to force it.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (860) 385-8584
Call (860) 385-8584